With the continuous development of the modern economic level and the gradual improvement of people's quality of life, smart homes have slowly entered thousands of households, bringing many conveniences to residents. As one of the more common smart home products, electric curtains are familiar to many people. An electric curtain is a kind of curtain opening and closing motor. If it is to open and close smoothly, it is inseparable from the operation and adjustment of the electric curtain opening and closing motor. Below, Awning Motors Factory introduces the adjustment knowledge of electric curtain motor:

1. The motor of the electric curtain opening and closing and the curtain closing are separated from the transmission box of the track so that the pulley of the track is in the terminal position of fully open and fully closed.

2. Rotate the positioning lock plate toward the knob, and then push the knob in. After hearing the "click" sound of the microswitch, you can see that it has an effect. Pull out the knob slightly to bring the gear into a meshing state, and the adjustment of the knob is finished.

3. Adjust the knob to turn the positioning locking piece onto the knob, and then press the knob to disengage the gear. Repeat all the adjustments of the above knobs to make the positioning micro switch enter the short-circuit state.

4. Install the motor on the track transmission box, and then push the pin piece into the transmission box to fix it. Turn on the power, power on the motor through the switch of the controller, and then turn the locking plate toward the knob; then push the knob in and rotate it slightly.

5. Switch the direction of the motor through the switch of the controller, push the locking piece to the knob, push the knob in and rotate it slightly, then immediately cut off the power of the motor, and then gently pull out the knob to move the gear into the gear meshing position.

6. When the knob and gear are in gear transmission, the electric curtain is adjusted.

7. Tighten the back cover with screws, so that the positioning lock piece is fixed.